![]() It can make the paint do some really weird things and not act right at all. Do watch out for that fish eye remover though. If you must you can use a little fisheye eliminator, but only if you absolutely need to. Acrylic Enamel is prone to fisheye easily. You need a good water trap and clean lines. Several substances can cause fish eye, but the main way to avoid these craters from forming on your car’s finish is to be sure to clean your car thoroughly before painting it. The term “fish eye” refers to a tiny crater that can form on a car’s paint job during or after the car is repainted. Use 50% less FISH EYE ELIMINATOR for second coat if needed. Add ¾ – 1 ½ ounce per 1 ½ gallon of blended epoxy and mix well. The small amount of the additive will not disturb the proper ratio of the hardener and resin blend. Pinholes are often caused by trapped air, trapped solvents and trapped moisture escaping from the film. Pinholes are small blisters whose surface has broken during the drying process. Allow sufficient flash off time before force drying, ensure that the correct drying temperature is not exceeded.Ensure that the surface is scrupulously clean.What is fisheye eliminator?ĭESCRIPTION FISH EYE ELIMINATOR is a special liquid additive that is formulated to allow epoxy systems to flow out on silicone or oil contaminated substrates, including existing epoxy and urethane floors. Any contaminants on the surface at all will result in fish eyes in the clear coat, so make sure you thoroughly clean the surface. How do you get rid of fisheye in clear coat?ĭampen a clean rag in mineral spirits and wipe the surface again the solvent cleaner will remove any grease, oil (including skin oil) or wax buildup. ![]() ![]() In car painting, the term “fish eye” refers to a tiny crater that can form on a car’s paint job during or after the car is repainted. They are usually caused by oil and grease on a coating substrate. If fisheyes appear in a basecoat, allow the color to flash then spray a mist coat over affected area.įish eyes are small, crater-like openings in the finish after it has been applied.Add the recommended fisheye eliminator and respray the affected area.Remove wet paint film with solvent, clean and refinish.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |